Freightliner — Century Class Maintenance Manual

Rear Axle 35 ture, the oil will run more freely and ensure that the axle is flushed. Detroit Drive Axle Lubricants * 4. Clean the fill and drain plugs. Change them if necessary. IMPORTANT: Lubricant used in Detroit rear axles must meet Mercedes-Benz specification 235.20 (mineral) or 235.8 (synthetic). Mobil Delvac Gear Oil A 80W-90 and Mobilube HD-A Plus 80W-90 meet specification 235.20. Mobil Delvac 1 Gear Oil 75W-90 and Mobilube 1 SHC 75W-90 meet specification 235.8. For more product information, see http://bevo.mercedes-benz.com. 4.1 For magnetic plugs, use a piece of key stock or any other convenient steel slug to short the two magnetic poles and divert the magnetic field.

4.2 Clean away the collected material depos- ited on each pole. Magnets will rapidly lose their effectiveness as collected mate- rial bridges the gap between the two poles. Type Ambient Temperature SAE Viscosity Grade * Detroit rear axles do not require the use of friction modifiers. There is no upper limit on the ambient temperature, but axle sump tem- perature must never exceed 250°F (121°C). Table 1, Detroit Drive Axle Lubricants Synthetic Oil (–40°C) and up 75W–90 4.3 After the first oil is changed, inspect the drain plug each time for large quantities of metal particles. 4.4 After cleaning, install the drain plug(s) and tighten to 30 lbf·ft (41 N·m).

Detroit Rear Axle Lubricant Capacity 5. Fill the axle with the recommended lubricant. See Table 1 for recommended drive axle lubri- cants and Table 2 for lubricant capacities. Axle Oil Capacity: Quarts (liters) Forward-Rear 15.9 (15.0) * NOTE: Some Detroit axles have a small tapped and plugged hole near and below the housing oil fill hole. This smaller hole is for a lubricant temperature indicator only, and should not be used as a fill or level hole. Single and Rearmost Tandem 10.6 (10.0) * * Actual oil capacity might vary slightly depending on gear ratio. Table 2, Detroit Rear Axle Lubricant Capacity 5.1 Fill the axle through the oil fill hole.

Lubri- cant should be level with the bottom of the oil fill hole. To check fluid level, see Fig. 2 . A 5.2 Install and tighten the fill plug 30 lbf·ft (41 N·m). B Detroit Drive Axle Lubricants * IMPORTANT: Lubricant used in Detroit rear axles must meet Mercedes-Benz specification 235.20 (mineral) or 235.8 (synthetic). Mobil Delvac Gear Oil A 80W-90 and Mobilube HD-A Plus 80W-90 meet specification 235.20. Mobil Delvac 1 Gear Oil 75W-90 and Mobilube 1 SHC 75W-90 meet specification 235.8. For more product information, see http://bevo.mercedes-benz.com. f350061a 10/05/2016 A. Correct (lube level at bottom of fill hole) B. Incorrect (lube level below fill hole) Fig.

2, Axle Lubricant Level Inspection Dana Spicer Type Ambient Temperature SAE Viscosity Grade Dana Spicer does not recommend the use of friction modifiers in any of their rear axles. Friction modifiers should be used in Dana Spicer rear axles only if a slip-stick condition is found, as described in the ve- Mineral Oil (–26.1°C) and up 80W–90 Century Class Trucks Maintenance Manual, January 2016 35/2