Freightliner — Century Class Maintenance Manual

Rear Axle 35 hicle driver’s manual. If you are experiencing a prob- lem with a Dana Spicer rear axle, see Group 35 of the Century Class Trucks Workshop Manual . 1. Park the vehicle on level ground, apply the park- ing brakes, and chock the tires. 2. Clean the area around, and including, the fill plug. Remove the plug from the oil fill hole (or standpipe if installed in the oil fill hole) located in the axle housing rear cover. See Fig. 3 . 1 2 1 f350017a 10/05/2016 1. Magnetic Strainer 2. Power Divider 2 Fig.

4, Dana Spicer Dual-Drive-Axle Magnetic Strainer WARNING f350018a 10/05/2016 Always wear eye protection when using com- pressed air to clean parts, as flying debris could cause permanent damage to unprotected eyes. Do not point the air stream in the direction of other persons. 1. Oil Fill Plug 2. Drain Plug Fig. 3, Axle Housing Drain and Fill Plugs 3. Place a drain pan under the rear axle drain plug. Remove the drain plug at the bottom of the axle housing and allow sufficient time for all old lubri- cant to run out. See Fig. 3 . 5.2 Wash the strainer in solvent, and blow it dry with compressed air to remove oil and metal particles. 4.

On dual-drive axles, also remove the plug at the bottom of the power divider to drain oil from the power divider. NOTE: Some dual-drive axles are equipped with a cylindrical magnetic strainer, below the lube pump on the front of the power divider cover, that must be removed and cleaned at each axle oil change. All rear axles are fitted with mag- netic drain and fill plugs. See Fig. 4 . 5.3 Install and tighten the magnetic strainer 40 to 60 lbf·ft (54 to 81 N·m). 6. Clean the fill plugs and drain plugs. To help clean magnetic plugs, a piece of key stock or any other convenient steel slug may be used to short the two magnetic poles and divert the mag- netic field. IMPORTANT:

Magnets will rapidly lose effective- ness as collected material bridges the gap be- tween the two poles. Clean or change the plugs before this occurs. It may be necessary to clean or change the plugs one or more times between lubrication change intervals. 5. Remove and clean the magnetic strainer, if so equipped. 5.1 Remove the magnetic strainer from the power divider cover. 7. After cleaning, install and tighten the drain plug(s) 40 to 60 lbf·ft (54 to 81 N·m). Century Class Trucks Maintenance Manual, January 2016 35/3