Freightliner — Century Class Maintenance Manual

Brakes 42 2. Remove the capscrews and reservoir from the cover. 3. Remove the cover tetraseal. 4. Drain the air tank, and disconnect the line from the evaporator outlet. Remove the check-valve retainer, spring, and disc. 5. Install the disc, spring, and check-valve retainer, and connect the line to the evaporator outlet. 6. Install the cover tetraseal. 7. Install the reservoir on the cover and tighten the capscrews. 8. Fill the reservoir with 40 ounces (1183 mL) of methyl alcohol, then install the filler cap. 1 42–05 Dana Spicer Camshaft Bracket Lubrication 2 f421384 10/07/2016 1. End Cover Assembly 2. Heater/Thermostat Terminals IMPORTANT:

Perform MOP 42–10 before lubri- cating the camshaft bracket. Pump grease into the camshaft bracket until it ap- pears at the slack adjuster end of the bracket. See Fig. 6 . Fig. 5, End Cover Terminals Location 42–04 Alcohol Evaporator Cleaning and Inspection Midland 1 Maintenance is required during both the freeze sea- son and the off season to keep the alcohol evapora- tor in good working order. Off Season 3 During the off season, drain the unit of alcohol. At regular engine service intervals, open the drain cock to remove moisture from the alcohol evaporator.

Be- fore reactivating the evaporator for the next freeze season, drain, disassemble, inspect, and steam- clean the unit of any sludge that may have accumu- lated. It is advisable to replace any rubber parts when assembling the alcohol evaporator. Perform this service just before the freeze season. Freeze Season Reactivation 2 A f420011a 10/07/2016 A. Grease Exit 1. Brake Chamber 2. Slack Adjuster 3. Non-Pressure-Relief Grease Fitting Fig. 6, Camshaft Bracket Lubrication 1. Remove the filler cap, and check the cap tet- raseal. Use an NLGI Grade 1 or Grade 2 multipurpose chas- sis grease.

If grease leaks out under the camhead, the camshaft bracket grease seal is worn or dam- Century Class Trucks Maintenance Manual, January 2016 42/6