Freightliner — Century Class Maintenance Manual

Brakes 42 aged. See Group 42 of the Century Class Trucks Workshop Manual for grease seal replacement in- structions. 42–06 Dana Spicer, Haldex, and Gunite Slack Adjuster Lubrication 1 IMPORTANT: Perform MOP 42–10 before lubri- cating the slack adjusters. Automatic slack adjusters that have a grease fitting, must be lubricated periodically to ensure proper brake operation. 2 WARNING Failure to lubricate slack adjusters could lead to dragging brakes or a brake failure, resulting in property damage, personal injury, or death. Dana Spicer and Haldex 09/17/97 f421649 1. Grease Fitting 2. Slack Adjuster NOTICE Fig.

7, Dana Spicer and Haldex Automatic Slack Adjuster Do not use moly-disulfide-loaded grease or oil. Both the life and reliability of the slack adjuster will be reduced if this type of grease is used. 42–07 Meritor Camshaft Bracket Lubrication Lubricate the automatic slack adjuster at the grease fitting. See Fig. 7 . Use standard chassis lubricant. IMPORTANT: Perform MOP 42–10 before lubri- cating the camshaft bracket. Gunite NOTE: If equipped with an extended- maintenance Q Plus brake system, the cam- shaft bracket will not have a grease fitting.

These camshafts use a special NLGI grade syn- thetic polyurea grease and do not require lubri- cation for 3 years or 500,000 miles (800 000 km), whichever comes first. The extended- maintenance camshaft bushings are lubricated during the brake reline service interval. For ser- vice and lubrication instructions, see Group 42 of the Century Class Trucks Workshop Manual . For operating temperatures of (–29°C) and higher, use Texaco Multifak EP-2 or Mobil Grease No. 77. For operating temperatures between (–29°C) and (–40°C), use Lubriplate Aero grease. Lubricate a Gunite automatic slack adjuster at the grease fitting until grease appears on the camshaft, or flows from the grease-relief. See Fig.

8 . The newest Gunite automatic slack adjusters are produced without a grease-relief. During lubrication with a grease gun, lubricant is forced through the drilled worm wheel onto the camshaft. Lubricate the automatic slack adjuster at the grease fitting until grease appears on the camshaft. See Fig. 8 . For camshaft brackets with grease fittings, use an NLGI Grade 1 or Grade 2 multipurpose chassis grease. Century Class Trucks Maintenance Manual, January 2016 42/7