Steering 46 46–00 Safety Precautions 46–02 Power Steering Fluid and Filter Changing Safety Precautions in this section apply to all procedures within this group. DANGER WARNING When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle cannot drop. Failure to follow these steps could result in serious personal injury or death. Fill only with approved clean fluid. Failure to use the proper fluid could cause seal deterioration and leaks. Fluid leaks could eventually cause loss of power steering assist.
This could lead to an acci- dent resulting in personal injury or property dam- age. Wear eye protection when changing the fluid and filter. 46–01 Drag Link Inspection 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires. WARNING 2. Place a drain pan under the power steering res- ervoir, and remove the steering gear-to-reservoir return hose at the reservoir. Drain the power steering fluid into the drain pan and dispose of the fluid properly. Plug the return line fitting on the reservoir. All steering system components are critical for safe operation of the vehicle.
Failure to maintain the steering system as specified may result in loss of steering control, which could lead to per- sonal injury and property damage. 3. Use the following procedure for Century Class Conventionals. For Argosy COEs, go to the next step. 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires. 3.1 Use one hand to apply downward pres- sure to the power steering reservoir cover. Remove the flanged nut and rub- ber washer. See Fig. 1 . Remove the cover. 2. Have someone turn the steering wheel from left to right. Check for movement between the ball stud end and the pitman arm, and between the ball stud end and the steering arm. NOTE:
Always replace the power steering reservoir filter when changing the fluid. If the ball stud end is loose, replace the drag link. 3. Check the ball stud castle nut for looseness. 3.2 Lift out the filter spring and the filter top plate, then remove the filter. It may be necessary to wiggle the filter to remove it from its base. Do not use pliers to aid in removal of the filter; pliers could cause metal chips to enter the steering system. Clean the inside of the reservoir using a lint-free cloth. If the castle nut is loose, replace it and the cotter pin. See Group 00 for torque specifications. 4.
Inspect the boot of the drag link at both the pit- man arm and the steering arm end for cracks, splits, or other damage. Replace the boot if needed. 5. Grasp the drag link near the pitman arm end, then push and pull laterally to check for axial movement in the ball stud end. If it is loose, re- place the drag link. See Group 46 of the Century Class Workshop Manual for replacement instruc- tions. If there is 1/8-inch (3-mm) movement or more, do not drive the vehicle until the drag link is replaced. IMPORTANT: Do not start the engine while draining the system. 3.3 Place the disconnected end of the steer- ing gear-to-reservoir hose in the drain pan.
Raise the front of the vehicle with a floor jack and support it with jack stands. Have someone turn the steering wheel to Century Class Trucks Maintenance Manual, January 2016 46/1