Freightliner — Century Class Maintenance Manual

Steering 46 1 3.6 Install the reservoir cover over the threaded shaft. Apply a slight downward pressure while installing the rubber washer and the flanged nut. Tighten the nut until it is snug. 2 3 4 7 4. Use the following procedure for Argosy COEs. 4.1 Remove the clamp that holds the cover on the reservoir. See Fig. 2 . Remove the cover. 9 8 1 5 2 6 6 4 3 5 f461070 11/28/95 1. Vented Fill Cap and Dipstick 2. Flanged Nut 3. Rubber Washer 4. Reservoir Cover 5. Filter Spring 6. Filter Top Plate 7. Reservoir Filter 8. Threaded Shaft 9. Power Steering Reservoir 07/09/98 f461670 1. Fill Cap 2. Filter Spring 3. Filter Top Plate 4. Clamp 5. Filter 6. Reservoir Cover Fig.

1, Power Steering Reservoir and Filter, Century Class Conventional Fig. 2, Power Steering Reservoir and Filter, Argosy COE NOTE: Always replace the power steering reservoir filter when changing the fluid. full lock left and right. Capture the fluid flowing from the hose in the drain pan. Add fluid to the reservoir, as needed. When clean power steering fluid flows from the hose, remove the plug from the reservoir and reconnect the steering gear- to-reservoir hose to the reservoir. Re- move the jack stands and lower the ve- hicle. 4.2 Lift out the filter spring and the filter top plate, then remove the filter. It may be necessary to wiggle the filter to remove it from its base.

Do not use pliers to aid in removal of the filter; pliers could cause metal chips to enter the steering system. Clean the inside of the reservoir using a lint-free cloth. 3.4 With the larger opening at the top, install a new filter in the reservoir. Install the fil- ter top plate so its center fits into the opening at the top of the filter. Install the filter spring. IMPORTANT: Do not start the engine while draining the system. 4.3 Place the disconnected end of the steer- ing gear-to-reservoir hose in the drain pan. Raise the front of the vehicle with a floor jack and support it with jack stands. Have someone turn the steering wheel to full lock left and right.

Capture the fluid flowing from the hose in the drain pan. 3.5 Clean the reservoir cover and O-ring seal. Inspect the O-ring and the cover for cracks, deformities, or damage. Replace the O-ring seal or cover as needed. Century Class Trucks Maintenance Manual, January 2016 46/2