Steering 46 Add fluid to the reservoir as needed. When clean power steering fluid flows from the hose, remove the plug from the reservoir and reconnect the steering gear- to-reservoir hose to the reservoir. Re- move the jack stands and lower the ve- hicle. On Century Class Conventionals, remove the dipstick and check that power steering fluid is between ADD HOT and FULL HOT. If the fluid level is low, add enough fluid to bring the level up to the FULL HOT mark on the dipstick. On Argosy COEs, check that power steering fluid is between the ADD HOT and FULL HOT lines on the transparent reservoir.
If necessary, add enough ATF fluid that meets Dexron III or TES- 389 specifications to bring the level up to the FULL HOT mark on the dipstick. 4.4 Install a new filter into the reservoir. In- stall the filter spring and the filter top plate. 4.5 Clean the reservoir cover and O-ring seal. Inspect the O-ring and the cover for cracks, deformities, or damage. Replace the O-ring seal or cover as needed. 46–04 Power Steering Gear Lubrication 4.6 Install the reservoir cover and the clamp. Tighten the clamp 25 lbf·in (280 N·cm). Sheppard Steering Gears 5.
Using ATF fluid that meets Dexron III or TES-389 specifications, fill the power steering reservoir with approved power steering fluid to the FULL COLD mark. Sheppard power steering gears manufactured with- out grease fittings are maintenance-free. If the power steering gear has no grease fitting, it requires no pe- riodic lubrication. 6. Start the engine and operate it at idle. Turn the steering wheel to full lock left and right to adjust the fluid level and remove any existing air from the power steering pump and gear. Recheck the fluid level. Add fluid as needed. The system is properly bled when the steering pump does not labor when turning the wheel.
Sheppard power steering gears with grease fittings must be lubricated periodically. 1. Wipe off any debris from the bearing cap grease fitting. See Fig. 3 . 7. Check for leaks in the power steering system, and repair as needed. Top off the power steering fluid level as needed. 46–03 Power Steering Fluid Level Inspection 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires. 2. With the engine cool, use a shop towel or clean rag to clean the area around the power steering reservoir fill cap. See Fig. 1 or Fig. 2 . Twist the cap counterclockwise to remove it. Check the cold power steering fluid level.
The level should be between ADD COLD and FULL COLD with the engine off. f460296a 1 05/28/93 1. Bearing Cap Grease Fitting Fig. 3, Sheppard Bearing Cap Lubrication 2. Using a hand-type grease gun, apply multipur- pose chassis grease until grease starts coming out of the bearing cap dirt-and-water seal. 3. Start the engine and run it at idle until it reaches operating temperature. Century Class Trucks Maintenance Manual, January 2016 46/3