Freightliner — Century Class Maintenance Manual

Steering 46 TRW Steering Gears NOTICE Apply grease to the sector shaft with a hand-type grease gun only. Use of a high-pressure power grease gun will supply grease too quickly and could affect the high pressure seal, contaminating the hydraulic fluid. 2 1 f461072 10/07/2016 Using a hand-type grease gun, apply NLGI Grade 2 or 3 multipurpose chassis grease until it starts to come out past the sector shaft seal. See Fig. 4 . 1. Grease Fitting at Pitman Arm 2. Grease Fitting at Axle Steering Arm Fig. 5, Drag Link 46–06 Rack and Pinion Steering Gear Inspection 1 WARNING All steering system components are critical for safe operation of the vehicle.

Failure to maintain the steering system as specified may result in loss of steering control, which could lead to per- sonal injury and property damage. Inspect the rack and pinion steering system as de- scribed below, and repair or replace any components that are worn or damaged. Figure 6 shows the com- ponents of the rack and pinion steering system. 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires. f461071 10/07/2016 1. Sector Shaft Grease Fitting 2. Check the steering I-shaft U-joints for evidence of looseness or binding. If any is found, replace the I-shaft. 46–05 Drag Link Lubrication Fig. 4, TRW Steering Gear Lubrication 3.

Check the steering I-shaft slip joint for evidence of lateral movement, looseness, or binding. If any is found, replace the I-shaft. 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires. 4. Jack up one axle end at a time, and move the tire in and out by hand to check the tie rod ends for free play. No free play is allowed. If the outer tie rod ends are damaged or worn, replace them. See Group 46 of the Century Class Trucks Workshop Manual for replacement instructions. 2. Using a clean rag, wipe all dirt from both drag link grease fittings. See Fig. 5 . 3.

Using a pressure gun and NLGI Grade 2 (8% 12-hydroxy lithium stearate grease) or NLGI Grade 1 (6% 12-hydroxy lithium stearate grease) chassis grease, apply clean grease at the grease fittings until old grease is forced out of the socket. 5. Check the steering gear mounting bolts for secu- rity. 6. Check that the outer tie rod castle nuts are tight, and the cotter pins are properly installed. Century Class Trucks Maintenance Manual, January 2016 46/4