Steering 46 11 16 12 15 10 13 6 7 8 9 14 17 3 2 5 4 19 20 21 8 9 18 22 23 5 1 3 4 07/24/2009 f462151 1. Steering Tie Rod Arm 2. Power Steering Fluid Lines 3. Large Bellows Clamp 4. Bellows 5. Small Bellows Clamp 6. Driver-Side Outer Tie Rod 7. Tie Rod Jam Nut 8. Inner Tie Rod Flat 9. Inner Tie Rod Ball Joint 10. Input Shaft Seal Cover 11. I-shaft Upper Yoke 12. I-shaft Lower Yoke Boot Clamp 13. I-shaft Lower Yoke Boot 14. I-shaft Lower End Yoke 15. Transfer Line Tube Fittings 16. Power Steering Fluid Line Fittings 17. I-shaft Slip Joint 18. Transfer Lines 19. Rack and Pinion Gear 20. Pinch Bolt 21. Tie Rod Clamp 22. Tie Rod Clamp Nut 23. Passenger-Side Outer Tie Rod Fig.
6, Rack and Pinion Steering System IMPORTANT: Do not remove the bellows unless they are damaged and require replacement, or there is evidence of a loose inner tie rod or there is hydraulic fluid leak. leaking from within the bellows, replace the steering gear. 9. Check the input shaft for any leakage around the input shaft seal cover. If there is evidence of leakage from inside the cover, remove it and re- place the input shaft seal. See Group 46 of the Century Class Trucks Workshop Manual for in- structions. 7. Use a clean rag to remove all dirt and debris from the bellows. Check the bellows for holes or tears. If any are found, replace the bellows. 8.
Check for evidence of hydraulic fluid leakage from the bellows. If hydraulic fluid is found to be Check the steering system pressure and return lines and fittings for leaks and damaged lines or Century Class Trucks Maintenance Manual, January 2016 46/5