Steering 46 hoses. Repair or replace lines, hoses, and fit- tings as necessary. 8. Remove the bellows from both sides of the gear. NOTE: A thin film of leftover Terostat MS 939 on the rack housing is acceptable when installing the new bellows. NOTICE Do not tighten the tube fittings on the hard trans- fer lines. Tightening the tube fittings can cause tearing of the O-ring seal and increased fluid leak- age. 9. If the housing has Terostat MS 939 on it from a previous replacement of the bellows, remove as much of the leftover Terostat from the housing sealing surface as possible. Wipe down the housing with brake cleaner to remove all remain- ing dirt and debris. 10.
Check the tube fittings on the hard transfer lines of the gear, see Fig. 6 , Item 15. If there is leak- age from either of the fittings, replace the steer- ing gear. IMPORTANT: Only apply grease to the rack shaft on the driver side. Do not apply grease to the teeth of the rack shaft. Do not apply grease to the shaft on the passenger side. 46-07 Bellows Replacement, Rack and Pinion Steering Gear 10. Turn the wheels all the way to the right to fully expose the driver-side rack. Without applying grease to the teeth of the rack shaft, evenly apply a light film of Renolit CX-FO 20 grease to the metal surfaces covered by the driver-side bellows. 1.
Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires. 2. Raise the front wheels off the ground and sup- port the vehicle with jack stands. NOTICE Two syringes of the Terostat MS 939 are included in the Bellows Service Kit. Ensure only Terostat, which is white in color, is applied to the rack housing. 3. Remove both wheels from the steer axle. NOTE: A Tiger Tool Slack Adjuster Puller, part number 10406, may be used to assist with re- moval of the outer tie rods. 4. Disconnect the outer tie rods from the steering arms, as follows. Do not allow Terostat MS 939 sealant to come into contact with the inner tie rods.
Mistakenly apply- ing sealant to the inner tie rods may cause dam- age to the bellows and the gear. See Fig. 6 . 4.1 Remove the cotter pins and castellated nuts. IMPORTANT: Terostat MS 939 sealant must be applied at a temperature between 41 and 104°F (5 and 40°C) to effectively seal steering gear components. Because Terostat sealant sets within ten minutes of application, the bellows must be installed within ten minutes of sealant application to ensure a good seal. 4.2 On the driver’s side, loosen the jam nut. See Fig. 6 . Note the number of exposed threads and the position of the outer tie rod to ease installation. 4.3 Disconnect the outer tie rods from the steering arms. 5.
Use brake cleaner to remove dirt and debris from both bellows and surrounding areas. 11. Evenly apply Terostat MS 939 sealant to the outer diameter of the rack housing where the large ends of the bellows seat on the gear hous- ing. See Fig. 8 . 6. Remove the small and large Oetiker clamps from both bellows. Discard the clamps. 7. Disconnect the outer tie rods from the inner tie rods. If necessary, use a backup wrench on the inner tie rod flat to turn the inner tie rod. See Fig. 6 . Century Class Trucks Maintenance Manual, January 2016 46/6