Engine 01 01–00 Safety Precautions 01–02 Engine Drive Belt Inspection Safety Precautions in this section apply to all procedures within this group. Worn or loose drive belts may cause premature bearing failure or engine overheating. Excessive ten- sion, or too little tension on the belt may result in ex- cessive and premature belt wear. Poly-V belts, or serpentine belts are retained by a belt tensioner that requires no tension adjustment. Replace the belt if any conditions described in "Visual Inspection" are found. V-belts are installed as individual belts, and as matched sets. When replacing matched sets of belts, always replace both belts at the same time.
Matched belts must be from the same manufacturer. To in- spect a belt, gently twist the belt to view the belt sidewalls and bottom. Inspect all drive belts for the following conditions, then perform the "Belt Tension Inspection": Visual Inspection DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle cannot drop. Failure to follow these steps could result in serious personal injury or death. 01–01 Engine Noise Panel Inspection (Noise Emission Control) If equipped, inspect for torn engine noise panels. See Fig.
1 for Caterpillar noise panel locations. If panels are torn, replace them with new panels; see Group 01 of the Century Class Trucks Workshop Manual for procedures. Cummins M11 and N14 en- gines, and Detroit Diesel Series 55 and Series 60 engines do not have engine noise panels. 1. Inspect the belt for glazing. See Fig. 2 , Ref. A. Glazing is represented by shiny sidewalls, and is caused by friction created when a loose belt slips in the pulleys. It can also be caused by oil or grease on the pulleys. 2. Check the belt for ply separation. See Fig. 2 , Ref. B. Oil, grease, or belt dressing can cause the belt to fall apart in layers.
Repair any oil or coolant leaks that are affecting the belts before replacing the drive belts. Do not use belt dress- ing on any belt. 2 3. Check the belt for a jagged or streaked sidewall. See Fig. 2 , Ref. C. Jagged or streaked sidewalls are the result of foreign objects, such as sand or gravel in the pulley, or a rough pulley surface. 4. Check for tensile breaks; breaks in the cord body. See Fig. 2 , Ref. D. Cuts in a belt are usu- ally caused by foreign objects in the pulley, or by prying or forcing the belt during removal or instal- lation. 1 5. Check for uneven ribs on serpentine (poly-V) belts. See Fig. 2 , Ref. E.
Foreign objects in the pulley will erode the undercord ribs, causing the belt to lose its gripping power. 11/29/95 f011040 1. Oil Pan Noise Panel (C10 engine only) 2. Left-Side Noise Panel (3406 engine only) 6. Check the drive belts for cracks. See Fig. 2 , Ref. F. Small irregular cracks are usually signs of an old belt. Fig. 1, Caterpillar Engine Noise Panels Century Class Trucks Maintenance Manual, January 2016 01/1