Freightliner — Century Class Maintenance Manual

Engine 01 7. Inspect the pulleys for excessive play or wobble. Excessive play or wobble indicates a failure of the pulley bearing. Check for belt squealing or squeaking. Replace bearings as needed. NOTE: If it is difficult to distinguish the location of a supposed bearing noise, place a stetho- scope on the component being checked, not the pulley, to isolate the area from outside interfer- ence. 3. If belt tension is not correct, see Group 01 of the Century Class Trucks Workshop Manual . Spring-Tension Type On belts equipped with a spring tensioner, the belt tension is automatically adjusted.

Check that the ten- sioner is holding tension on the belt by inserting the end of a breaker bar in the 1/2-inch square hole on the forward face of the tensioner, and rotating the tensioner down, away from the belt. When the breaker bar is slowly released, the tensioner should 8. Inspect all pulleys for foreign objects, oil, or grease in the grooves. A D B E F 11/21/94 C f150010a A. Glazing B. Separating Layers C. Streaked Sidewalls D. Tensile Break E. Uneven Ribs F. Cracks Fig. 2, Drive Belt Replacement Conditions Belt Tension Inspection Threaded-Adjustment Type return to its original position. If not, see Group 01 of the Century Class Trucks Workshop Manual for re- placement instructions.

1. Apply the parking brakes, and chock the tires to prevent the vehicle from moving. 2. Install a belt tension gauge at the center of the belt’s longest free-span. Check belt tension. See Table 1 for belt tension specifications. Century Class Trucks Maintenance Manual, January 2016 01/2