Engine 01 01–03 Engine Mount Inspection (Noise Emission Control) and upper isolators (see Fig. 3 , Refs. 1 and 6), and replace them if they are worn. See Group 01 of the Century Class Trucks Workshop Manual for procedures. NOTE: At engine overhaul, and whenever the engine has been removed, inspect the lower Drive Belt Tension Caterpillar C10 (3176) Refrigerant Compressor 80 to 100 (36 to 45) Engine Component Belt Tension:
lbf (kg) Caterpillar 3406E Alternator and Refrigerant Compressor 40 to 50 (18 to 23), per belt Fan 80 to 100 (36 to 45) Cummins M11 Alternator 90 to 120 (41 to 55) Fan 155 to 165 (70 to 75) Refrigerant Compressor 80 to 100 (36 to 45) Alternator 40 to 50 (18 to 23), per belt Cummins N14 Fan 80 to 120 (36 to 55) Refrigerant Compressor 80 to 100 (36 to 45) Detroit Diesel Series 60 Alternator and Refrigerant Compressor 80 to 100 (36 to 45), Power Band Fan 60 to 80 (27 to 36) Table 1, Drive Belt Tension Periodically inspect the rubber isolators for cracks, cuts, wear, or damage, and replace them if neces- sary.
See Group 01 of the Century Class Trucks Workshop Manual for isolator replacement procedures. 2 6 01–04 Engine-Support Fasteners Check (Noise Emission Control) 1 Front and rear engine supports for vehicles built from January 2007 require no periodic maintenance. Mounts should be inspected when the engine is re- moved for service. For vehicles manufactured prior to January 2007, perform the following check. 2 3 4 5 10/05/94 f220047a Check the rear engine-support fasteners (see Fig. 3 , Ref. 4) for tightness. Tighten the 3/4-inch fasteners 215 to 265 lbf·ft (292 to 359 N·m). 1. Lower Isolator 2. Engine-Support Washer 3. 3/4–10 Capscrew 4. 3/4–10 Hexnut 5. Engine Mount 6. Upper Isolator Fig.
3, Rear Engine Mount Isolators and Fasteners Century Class Trucks Maintenance Manual, January 2016 01/3