Freightliner — Century Class Maintenance Manual

Engine Cooling/Radiator 20 20–00 Safety Precautions 3. There is a second valve in the radiator cap that opens under vacuum. This prevents the collapse of hoses and other parts that are not internally supported when the system cools. Inspect the vacuum-relief valve to be sure it is not stuck. Safety Precautions in this section apply to all procedures within this group. DANGER 4. Make sure that the cap seals properly on the coolant filler neck seat, and that the radiator cap gasket is not damaged. On vehicles with screw on caps with O-rings, make sure that the O-ring is not cracked or deteriorated. Replace the cap if the gasket shows deterioration or damage.

When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle cannot drop. Failure to follow these steps could result in serious personal injury or death. 20–02 Radiator Pressure- Flushing and Coolant Change 20–01 Pressure Relief Cap Check NOTE: For additional instructions on cleaning and flushing the engine’s cooling system, see the applicable engine manufacturer’s mainte- nance and operation manual. WARNING Do not remove or loosen the surge tank cap until the engine and cooling system have completely cooled. Use extreme care when removing the cap.

A sudden release of pressure from removing the cap prior to the system cooling can result in a surge of scalding coolant that could cause seri- ous personal injury. 1. Park the vehicle, apply the parking brakes. Tilt the hood or cab. For instructions on tilting the cab, see Group 60 of the Century Class Trucks Workshop Manual . 2. Place a suitable container under the elbow of the radiator outlet pipe and under the radiator. The container should hold at least 60 quarts (58.6 liters) of fluid for single radiator applications, or 80 quarts (76 liters) for Argosy’s with auxiliary radiators. CAUTION The radiator cap currently installed may not be the same one installed when the vehicle was built.

If the radiator cap must be replaced, make sure that it is the correct cap for the cooling system of the vehicle. Because the radiator cap pressure rating affects the operating temperature of the engine, installing an improperly rated radiator cap may have adverse effects on the cooling system, and engine operating temperatures. This could cause premature engine wear or damage. WARNING Do not remove or loosen the surge tank cap until the engine and cooling system have completely cooled. Use extreme care when removing the cap. A sudden release of pressure from removing the cap prior to the system cooling can result in a surge of scalding coolant that could cause seri- ous personal injury. 1.

Remove the fill cap first, to relieve the cooling system pressure, then remove the SAE cap. 3. Remove the surge tank cap. 2. Using a radiator-cap tester, check the pressure cap to see if it maintains pressure to within 10% of the pressure rating marked on the cap. If it doesn’t, replace the cap. See Fig. 1 or Fig. 2 . Make sure that the replacement radiator cap is correctly rated for the cooling system of the vehicle. 4. On Argosy’s with auxiliary radiators, open the remote bleed valve. See Fig. 3 . Century Class Trucks Maintenance Manual, January 2016 20/1