Freightliner — Century Class Maintenance Manual

Engine Cooling/Radiator 20 10.1 Connect the halves of the fan solenoid connector. 10.2 Turn the air conditioner off. 2 3 10.3 Start the engine and charge the air sys- tem to 120 psi (827 kPa). Tests must be performed with the engine temperature below 205°F (96°C) for Caterpillar en- gines, and below 200°F (93°C) for Cum- mins and Detroit Diesel engines. 1 4 10.4 Set the toggle switch to the ON position; the fan clutch should engage. 5 10.5 Apply the foot brake, and release the parking brakes. 10.6 Set the toggle switch to the AUTO or OFF position; the air should exhaust and the fan clutch should disengage. Replace the switch if necessary.

A 05/27/93 6 f200237a With the fan clutch engaged, measure the distance at A ; measure it again with the fan clutch disengaged. 11. If the fan stays engaged at all times on a Detroit Diesel engine, check the circuit breaker labeled "engine fan." Kysor K22RA Fan Clutch 1. Bearing Housing 2. Retaining Plate 3. Fan Pulley 4. Air Inlet (from solenoid valve) 5. Air Cylinder 6. Fan 1. Disconnect the electrical cables from the battery. Drain all air from the air system. If equipped with an air starter, drain the air starter reservoir. Fig. 9, Kysor K22RA Fan Clutch Lining Wear Checking Class Trucks Workshop Manual for clutch lining replacement instructions. WARNING 6.

Release the air pressure, then disconnect the shop hose from the air inlet of the air cylinder. Connect the vehicle air hose to the inlet. If the engine starts during this procedure, the fan could cause personal injury. If the vehicle is equipped with an air starter, be sure that the air starter reservoir is drained. 7. Connect the electrical cables to the battery. 8. Start the engine. 2. Measure the distance from the back surface of the fan clutch retaining plate to the forward-most edge of the fan belt pulley. See Fig. 9 , Ref. A. Horton DriveMaster® Fan Clutch NOTE:

If any part of the fan clutch needs to be repaired or replaced after performing the checks below, see Group 20 of the Century Class Trucks Workshop Manual . 3. Disconnect the line from the air inlet of the air cylinder. Connect a shop air hose to the inlet. 4. Apply a minimum of 100 psi (690 kPa) air pres- sure to the air cylinder—the bearing housing will move backwards, disengaging the clutch. Again, measure the distance from the back surface of the retaining plate to the forward-most edge of the fan belt pulley. 1. Disconnect the batteries at the negative termi- nals. Drain all air from the air system. If equipped with an air starter, drain the air starter reservoir. 5.

Compare the two measurements; if the difference between the two measurements exceeds 0.150 inches (3.8 mm), the clutch lining is worn and must be replaced. See Group 20 of the Century WARNING Make sure the batteries are disconnected before checking the fan clutch. If the engine starts during Century Class Trucks Maintenance Manual, January 2016 20/7