Engine Cooling/Radiator 20 8. With the air system charged to 120 psi (827 kPa), and with the fan solenoid connector halves separated, check the fan clutch for audible air leaks, using a suitable listening device. age means that the large O-ring (Ref. 14) is damaged. 9.3 Check for air leaks around the safeguard hole on the piston friction disc. Air leak- age means the small O-ring (Ref. 18) is damaged. 9. If a leak is detected, remove the fan blade. Using a soapy water solution, check the fan clutch at the following locations to locate the source of the leak. Install a new seal kit. See Group 20 of the Century Class Trucks Workshop Manual for re- pair procedures.
9.4 Check for air leaking from the System Sentry® fuse. Leaking air means the clutch has gotten so hot the lead alloy in the fuse melted. This released the clutch before the heat could damage the clutch bearings. Before replacing the fuse, find and repair the source of the heat. 9.1 Check for a leak at the bleed hole on the fan pilot. Air leakage means that the car- tridge assembly ( Fig. 8 , Ref. 16) or face seal (Ref. 17) is damaged. 6 7 8 5 19 20 18 21 23 22 3 4 17 1 2 14 15 13 16 11 12 9 10 24 03/30/95 f200194a 1. Mounting Bracket 2. Rear Sheave Bearing 3. Inner and Outer Bearing Spacers 4. Forward Sheave Bearing 5. Sheave 6. Friction Facing 7. Journal Spacer 8. Socket-Head Capscrew 9.
Rear Hub Bearing 10. Bearing Spacer 11. Splined Hub 12. Forward Hub Bearing 13. Piston Friction Disc 14. Large O-Ring 15. Locknut 16. Cartridge Assembly 17. Face Seal 18. Small O-Ring 19. Air Chamber 20. Socket-Head Capscrew 21. Stud Bolt 22. Lockwasher 23. Hexnut 24. Piston Assembly Fig. 8, Horton Advantage Fan Clutch Components 9.2 Check for air leaks between the air cham- ber and the piston friction disc. Air leak- 10. If equipped with an override toggle switch on the dash, check the fan clutch operation as follows: Century Class Trucks Maintenance Manual, January 2016 20/6