Freightliner — Century Class Maintenance Manual

Engine Cooling/Radiator 20 radiator and hoses for leaks. Repair if necessary. 3. Clean the fan clutch air solenoid valve filter, if equipped. 12.5 Shut off the engine, then check the cool- ant level in the surge tank. Add coolant if the level is not between the MIN and MAX lines on the surge tank. 3.1 Unscrew the fan clutch solenoid valve air filter assembly and remove the filter ele- ment. 3.2 Clean the filter element with cleaning sol- vent. 13. On Argosy’s with auxiliary radiators, bleed the system while adding coolant as follows. 13.1 Open the remote bleed valve on the left side of the frontwall. 3.3 Reassemble the clutch valve solenoid air filter assembly and install on the vehicle. 4.

Visually check the fan for bent, cracked, or dam- aged blades. Replace if damaged. Check for ad- equate clearance between the fan and other components. 13.2 Fill the cooling system at the surge tank; continue adding coolant until a non- aerated coolant stream comes out of the remote bleed valve. This allows air to be expelled from the auxiliary system. 5. Check the fan belt for wear, tension, and align- ment. Correct if necessary. 13.3 Close the remote bleed valve. 13.4 Continue filling until the coolant reaches the high level mark on the surge tank. 6. Check for wear on the friction facing. See Fig. 7 . Replace the friction facing if it is worn to a 1/16- inch (1.6-mm) thickness or less.

Also check the facing for signs of oil contamination or burn marks. If evidence of oil or burn marks are found, replace the friction facing. 13.5 Run the engine for 5 minutes to allow the system to de-aerate. 13.6 Check the coolant level again; add cool- ant to the high level mark. 3 4 20–03 Fan Clutch Check (Noise Emission Control) 2 5 Horton Advantage® Fan Clutch NOTE: If any part of the fan clutch needs to be repaired or replaced, after performing the checks below, see Group 20 of the Century Class Trucks Workshop Manual . 1 08/08/94 1. System Sentry® Fuse 2. Safeguard Hole 3. Friction Facing 4. Piston Friction Disc 5. Air Chamber f200290 1.

Disconnect the electrical cables from the battery. Drain all air from the air system. If equipped with an air starter, drain the air starter reservoir. Fig. 7, Horton Advantage Fan Clutch WARNING 7. Connect the battery cables. Start the engine, and charge the air system to 120 psi (827 kPa). Shut down the engine. Separate the halves of the fan solenoid connector. The fan clutch should en- gage. If the engine starts during this procedure, the fan could cause personal injury. If the vehicle is equipped with an air starter, be sure that the air starter reservoir is drained.

If the fan does not operate correctly, see Group 20 of the Century Class Trucks Workshop Manual for troubleshooting and repair proce- dures. 2. Inspect the electrical connections and wires to the fan clutch solenoid. Secure the connection if loose; replace wires and connectors if damaged. Century Class Trucks Maintenance Manual, January 2016 20/5