Engine Cooling/Radiator 20 1 f200286 10/05/2016 A. The screw tip must extend about 1/4 inch (6 mm). B. Belleville washer stacks must be collapsed almost flat. 1. Tightening Screw Hex 1 06/29/95 f011008 Fig. 6, Breeze Constant-Torque Hose Clamp Installation NOTE: Cummins M11 engine shown. pressure. During vehicle operation and shut- down, the screw tip may adjust according to temperature and pressure changes. The torque may need to be adjusted for individual applica- tions. 1. Coolant Drain Plug Fig. 4, Coolant Drain Plug Location install these hose clamps correctly. The correct installation torque is as follows: 9. Place a pan under the coolant filter to catch en- gine coolant.
For Breeze Constant-Torque clamps with a 5/16- inch tightening screw hex: 55 lbf·in (620 N·cm). 10. Remove the coolant filter with a strap or chain wrench. Install a new coolant filter and tighten. For Breeze Constant-Torque clamps with a 3/8- inch tightening screw hex: 90 lbf·in (1020 N·cm). IMPORTANT: On vehicles with EPA07 compliant engines, the coolant capacity varies depending on the engine and accessory installation. After servicing the cooling system, always verify that the coolant level is between the MIN and MAX lines on the surge tank. 11. Fill the cooling system with new coolant. Refer to the engine manufacturer’s service literature for specific coolant information. 12.
On single radiator applications, add coolant as follows. 12.1 Fill the cooling system at the surge tank. f200326 10/05/2016 12.2 Install the surge tank cap. 12.3 Return the hood or cab to the operating position. See Group 60 of the Century Class Trucks Workshop Manual for cab tilt instructions. Fig. 5, T-Bolt Type Hose Clamp NOTE: All hose clamps will lose torque after installation due to "compression set." However, when correctly installed, Breeze Constant- Torque clamps will hold enough torque to auto- matically adjust and keep consistent sealing 12.4 Start the engine and turn on the cab heater. Allow the engine to warm up to normal operating temperature.
Check the Century Class Trucks Maintenance Manual, January 2016 20/4 B A 1 B 1