Freightliner — Century Class Maintenance Manual

Engine Cooling/Radiator 20 1 4 5 9 2 6 3 8 7 08/19/2009 f200726 NOTE: The main radiator drain plug is not shown. 1. Surge Tank 2. Remote Bleed Valve 3. Main Radiator 4. Auxiliary Radiator 5. Auxiliary Radiator Temperature Sensor 6. Fan Power Harness 7. Auxiliary Radiator Drain Plug 8. Cold Coolant Hose 9. Hot Coolant Hose Fig. 3, Coolant System, Argosy, with Auxiliary Radiator 7.3 Gradually, apply air pressure to help dis- lodge sediment built up in the radiator core. Do not apply more than 15 psi (103 kPa) air pressure to the radiator. Pres- sures exceeding 15 psi (103 kPa) could damage the radiator core. 8. Connect the hoses.

The hose clamps on the main radiator can be either T-bolt clamps (see Fig. 5 ) or Breeze Constant-Torque clamps (see Fig. 6 ). When working with T-bolt hose clamps, tighten the clamps 55 lbf·in (620 N·cm). These clamps are now standard on hoses with an inside diam- eter greater than 2 inches (51 mm). 7.4 Shut off the air at the pressure gun nozzle and allow the radiator to refill with water. When installing Breeze Constant-Torque hose clamps, the clamps must be tightened to the cor- rect torque. The screw tip of the clamp must ex- tend about 1/4 inch (6 mm) from the clamp hous- ing, and the Belleville washer stacks must be collapsed almost flat.

Use a torque wrench to 7.5 Repeat the previous two steps until clean water flows from the radiator. 7.6 Remove the radiator side tank drain plug and allow the radiator to drain. Century Class Trucks Maintenance Manual, January 2016 20/3