Freightliner — Century Class Maintenance Manual

Clutch 25 25–00 Safety Precautions Safety Precautions in this section apply to all procedures within this group. DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle cannot drop. Failure to follow these steps could result in serious personal injury or death. 25–01 Eaton Fuller Clutch Release Bearing Lubrication The standard clutch release bearing is sealed, and does not require lubrication. If the vehicle is equipped with an optional clutch release bearing with a grease fitting, lubricate the bearing as follows: f250081a 05/27/93 Fig.

1, Release Bearing Grease Fitting failure. Do not use chassis grease or multipurpose lubricants. 1. Park the vehicle on a level surface. Apply the parking brakes, and chock the rear tires. 2. Remove the clutch inspection plate. NOTE: Some clutch release bearings are equipped with a lubrication extension that ex- tends outside of the clutch housing. It is not necessary to remove the clutch inspection plate when the lubrication extension is used. 4. Wipe off excess grease and apply it to both the yoke-finger and the sleeve-bushing contact points. See Fig. 2 . 1 NOTE:

For lubrication of the release bearing, Eaton fuller recommends a lithium-base high- temperature grease that meets the NLGI grade one or two specification. 3. Wipe any dirt away from the grease fitting. See Fig. 1 . Use a pressure-type grease gun equipped with the recommended grease, and lubricate the bearing until excess grease purges from the rear of the release bearing (toward the transmission). 2 08/10/2009 f250444 1. Sleeve-Bushing Contact Point 2. Yoke-Finger Contact Points 5. Install the clutch inspection plate. Fig. 2, Grease the Contact Points CAUTION 6. Remove the chocks. Do not over-lubricate the clutch release bearing.

Over-lubrication could contaminate the clutch in- ternally, causing clutch slippage and premature Century Class Trucks Maintenance Manual, January 2016 25/1