Freightliner — Century Class Maintenance Manual

Clutch 25 25–02 Clutch Release Cross- Shaft Lubrication 25–03 Sleeve Assembly Bronze Bushing Lubrication The clutch release cross-shaft is equipped with two grease fittings in the transmission clutch housing. See Fig. 3 and Fig. 4 . Wipe any dirt from the grease fittings, then lubricate with multipurpose chassis grease. Vehicles equipped with the sealed clutch-release bearing have a lubrication extension outside of the clutch housing. This extension is needed to provide lubrication to the bronze bushing located between the clutch bearing housing and the transmission input shaft.

Use a pressure-type grease gun equipped with high-temperature grease only, and lubricate until grease flows from the release bearing housing. De- press the clutch pedal a couple of times before start- ing the engine. 25–04 Meritor Clutch Release Bearing Lubrication 1 2 The standard clutch release bearing is sealed, and does not require lubrication. If the vehicle is equipped with an optional clutch release bearing with a grease fitting, lubricate the bearing as follows: 1. Park the vehicle on a level surface. Apply the parking brakes, and chock the rear tires. 10/19/93 1. Clutch Release Cross-Shaft 2. Grease Fitting f250048a 2. Remove the clutch inspection plate. NOTE:

Some clutch release bearings are equipped with a lubrication extension that ex- tends outside of the clutch housing. It is not necessary to remove the clutch inspection plate when the lubrication extension is used. Fig. 3, Cross-Shaft Grease Fitting, Left-Side NOTE: For lubrication of the release bearing, Meritor recommends a lithium-base high- temperature grease that meets the NLGI grade three specification. 3. Wipe any dirt away from the grease fitting. See Fig. 1 . Use a pressure-type grease gun equipped with the recommended grease, and lubricate the bearing until excess grease purges from the rear of the release bearing (toward the transmission). f260146a 05/27/93 Fig.

4, Cross-Shaft Grease Fitting, Right-Side CAUTION Do not over-lubricate the clutch release bearing. Over-lubrication could contaminate the clutch in- ternally, causing clutch slippage and premature failure. Do not use chassis grease or multipurpose lubricants. Century Class Trucks Maintenance Manual, January 2016 25/2