Freightliner — Century Class Maintenance Manual

Transmission 26 Fuller® transmission lubricant capacities and Table 3 for Meritor transmission lubricant capaci- ties. Eaton Fuller Transmission Lubricant Capacities Transmission Model * Refill Capacity : qt (L) For more information and a complete listing of Eaton approved lubricants, refer to the Eaton website, www.roadranger.com . For more infor- mation and a complete listing of Meritor ap- proved lubricants, refer to the ZF Meritor web- site, www.zf.com . 7-Speed T Series All Models 18.0 (17.0) All Models 13.5 (12.8) All 9-Speed Series NOTE: In all cases, the correct fluid level is es- tablished by checking at the fill opening.

All 10-Speed Manual Models (except deep reduction) FR and FRO Series 11.75 (11.0) 7. Operate the engine for five minutes after filling the transmission, then check the fluid level again. RT and RTX Series 13.0 (12.3) RTLO Series 14.0 (13.2) RTO–16210C 11.75 (11.0) 10-Speed Deep Reduction RTO/RTX–11708LL 14.0 (13.2) RTO–11908LL RTO/RTX–14708LL 14.5 (13.7) 10-Speed Automated Models f260006a 05/27/93 A B Lightning Top 2 (all) 13.5 (12.8) 10-Speed Autoshift AS2 (all) 13.0 (12.3) A. Full B. Low Fig. 1, Checking Transmission Fluid Level 13-Speed RTLO Series All Models 14.0 (13.2) Transmission Model Lubricant Type * Temp.

Range SAE Viscosity Eaton and Meritor Approved Transmission Lubricants All Models 14.0 (13.2) All 15-Speed Series All 18-Speed Series Synthetic transmission lubricant meeting Eaton PS-386 lubricant specification Eaton Fuller Transmissions RTLO Series 14.0 (13.2) 18-Speed Autoshift AS2 (all) All Eaton Fuller All * For models not listed in this table see the Eaton Fuller website, ww- w.roadranger.com . Quantities listed are approximate. Fill the transmission until lubricant is level with bottom of the fill hole, with the vehicle in normal operating posi- tion.

Table 2, Eaton Fuller Transmission Lubricant Capacities FreedomLine Mobil Delvac Synthetic Transmission Fluid 50 All 50W Meritor Transmissions All other Meritor Synthetic engine oil meeting Meritor specification 0–81, or MIL–L–2104D or E All 50W 8. Clean the fill plug, then install it in the transmis- sion. Tighten the plug as follows: 25 to 35 lbf·ft (34 to 48 N·m) for Eaton Fuller transmissions with 3/4-inch pipe threads. * Do not mix types or brands of fluid. Multiweight and extreme-pressure gear fluids are not recommended. Table 1, Eaton and Meritor Approved Transmission Lubricants 60 to 75 lbf·ft (81 to 102 N·m) for Eaton Fuller transmissions with 1-1/4-inch pipe threads.

Century Class Trucks Maintenance Manual, August 2017 26/2