Transmission 26 44 lbf·ft (60 N·m) for all ZF Meritor FreedomLine automated transmissions. mission reaches normal operating temperature: 160 to 200°F (71 to 93°C). 35 to 50 lbf·ft (48 to 67 N·m) for all other Meritor transmissions. 2. Park the vehicle on a level surface. Apply the parking brakes and chock the rear tires. 9. Operate the vehicle to check for correct opera- tion. 3. Clean the area around the drain plug and the transmission fluid pan. Place a drain pan under the transmission and remove the drain plug. Ex- amine the fluid as it drains. Meritor Transmission Lubricant Capacities Transmission Model Refill Capacity * : qt (L) 4.
Remove the 12 mounting bolts (six each) from the two filter covers. Meritor M/MO Series M/MO (all) 10.25 (9.7) NOTE: A lot of fluid will drain when the filter covers are removed. Meritor 9- and 10-Speed 5. Remove the filter covers, O-rings, and two square-cut seals from the transmission. See Fig. 2 . –115A/B/C/R (all) 10.0 (9.5) –125A/B/C/R (all) –135A/B/C/R (all) 6. Remove the filters from the bottom of the control module. 10.25 (9.7) –145A/B/C/R (all) 7. Lubricate the new O-rings with transmission fluid, and install them on the cover assemblies. –155A/B/C/R (all) Meritor 13-Speed RM013–145A 11.0 (10.4) 8.
Install a new square-cut seal on each cover as- sembly, and install the fluid filter elements on the cover assemblies. ZF Meritor FreedomLine 9. Install the filter and cover assemblies into the filter compartment. All 12-Speed Models 11.6 (11.0) All 16-Speed Models 12.5 (11.8) * Quantities listed are approximate. Fill the transmission until lubricant is level with bottom of the fill hole, with the vehicle in normal operating posi- tion. Table 3, Meritor Transmission Lubricant Capacities 10. Align each cover assembly with the holes in the channel plate sump, and push the cover assem- blies in by hand to seat the seals.
NOTICE 26–02 Allison Transmission Fluid and Filter Change Do not use the bolts to draw the filter covers to the sump. This can damage the covers, seals, or sump. When draining transmission fluid, check for evidence of dirt or water contamination. A small amount of condensation will appear in the fluid during operation. 11. Install six bolts in each cover, and torque the bolts 38 to 44 lbf·ft (51 to 61 N·m). 12. Replace the drain plug O-ring, and install the drain plug. Tighten the drain plug 18 to 24 lbf·ft (25 to 32 N·m). Water contamination is normally characterized as a milky discoloration of the transmission fluid.
Obvious contamination of the transmission fluid indicates a leak between the water and fluid areas of the trans- mission cooler. Inspect and pressure-test the cooler to confirm the leak; replace leaking transmission coolers. 13. Refill the transmission with fresh automatic trans- mission fluid and check the fluid level. See Table 4 for transmission lubricant capacities, and Table 5 for approved transmission lubricants. 1. Drain the transmission when the fluid is warm. If not already warm, run the engine until the trans- Century Class Trucks Maintenance Manual, August 2017 26/3