Freightliner — Century Class Maintenance Manual

Transmission 26 through the filter element (inside to outside) to loosen surface dirt and to dry the element. If it is not damaged, the sintered metallic filter element will last the life of the vehicle. Wipe out the filter housing with a clean, dry, lint- free rag. Clean and inspect the O-rings and the end cap. Replace any parts that are damaged. 5. Install the large O-ring, then the filter element (small end first) into the filter housing. 6. Install the small O-ring in the end cap, then in- stall the end cap and tighten it until firm. NOTICE A leaking air filter or air lines can cause slow or hard shifting of the transmission, and eventual transmission damage. 7.

Start the engine, and build pressure in the air system. Check for air leaks at the filter housing and air line connections; repair any leaks. Meritor f260037a 10/05/2016 Fig. 3, Air Filter/Regulator (Eaton Fuller transmission shown) NOTE: This procedure does not apply to FreedomLine transmissions. 2 3 4 5 6 7 1. Park the vehicle on a level surface. Apply the parking brakes and chock the rear tires. 2. Remove the element from the air filter/regulator assembly. Inspect the O-rings in the end cap; replace worn or damaged O-rings. Inspect the element for fluid contamination. If fluid is present, replace the element.

Inspect the air supply sys- tem for the source of the fluid, and service it as needed. 1 f260052a 10/17/2001 1. Air Regulator 2. Housing 3. Large O-Ring 4. Filter Element 5. Small O-Ring 6. End Cap 7. Plug 3. Install the element in the filter/regulator assem- bly. 4. Apply a light coat of silicone grease, or an equivalent grease to the O-rings in the end cap. Install and tighten the end cap 10 to 15 lbf·ft (14 to 20 N·m). Fig. 4, Eaton Fuller Transmission Air Filter/Regulator Components 5. Build air pressure in the system, check for leaks, and make any needed repairs. WARNING Wear safety goggles when using compressed air to clean parts, as permanent harm to eyes could result from flying debris.

4. Clean the filter element by dipping it in alcohol or other cleaning solvent. Blow compressed air Century Class Trucks Maintenance Manual, August 2017 26/5