Freightliner — Century Class Maintenance Manual

Transmission 26 26–04 Transmission Fluid Level Inspection If the fluid level is not within the COLD RUN band, add or drain fluid as needed to adjust the fluid level to the middle of the COLD RUN band. See Fig. 5 . Allison B NOTICE Operating a transmission with the fluid level higher or lower than recommended can result in transmission damage. Do not overfill the transmis- sion. A Do not mix types and brands of fluid, because of possible incompatibility. Do not use fluid addi- tives, friction modifiers, extreme-pressure gear fluids, or multiviscosity lubricants. Cold Check 12/01/97 A. Cold Run Band B. Hot Run Band f270002a Fig.

5, Dipstick Markings NOTICE Clean all dirt from around the end of the fluid fill tube before removing the dipstick. Do not allow foreign matter to enter the transmission. Dirt or foreign mat- ter in the hydraulic system may cause undue wear of transmission parts, make valves stick, and clog pas- sages. As the fluid temperature increases, so does the fluid level. Do not fill above the COLD RUN band if the transmission fluid is below normal operating temperature. NOTE: Perform a hot check at the first opportu- nity after the normal operating temperature, 160 to 200°F (71 to 93°C), has been reached.

It is important to check the fluid level cold to deter- mine if the transmission has a sufficient amount of fluid to be safely operated until a hot check can be performed. Hot Check 1. Park the vehicle on a flat, level surface. 1. Park the vehicle on a flat, level surface. Apply the parking brakes and chock the rear tires. 2. Apply the parking brakes and chock the rear tires. 3. Run the engine for at least one minute. 2. Shift the transmission to NEUTRAL. 3. Operate the engine at idle (500 to 800 rpm) until normal operating temperature is reached. Check that the sump temperature is 160 to 200°F (71 to 93°C). Check that the converter-out temperature is 180 to 220°F (82 to 104°C). 4.

Shift from DRIVE to NEUTRAL, and then shift to REVERSE to fill the hydraulic system. 5. Shift to NEUTRAL and allow the engine to idle at 500 to 800 rpm. 6. With the engine running at idle, remove the dip- stick from the tube and wipe it clean. 4. With the engine idling, remove the dipstick from the tube and wipe it clean. 7. Insert the dipstick into the tube and remove the dipstick. 5. Insert the dipstick into the tube and remove the dipstick. 8. Check the fluid level reading and repeat the check procedure to verify the reading. 6. Check the fluid level reading and repeat the check procedure to verify the reading. Safe oper- ating level is within the HOT RUN band on the dipstick.

The HOT RUN band is between the HOT FULL and HOT ADD marks. If the fluid level is within the COLD RUN band, the transmission may be operated until the fluid is hot enough to perform a hot check. Century Class Trucks Maintenance Manual, August 2017 26/6