Transmission 26 If the fluid level is not within the HOT RUN band, add or drain fluid as needed to bring the fluid level within the HOT RUN band. See Fig. 5 . 35 to 50 lbf·ft (48 to 67 N·m) for all other Meritor transmissions. Eaton Fuller and Meritor NOTICE Operating a transmission with the fluid level higher or lower than recommended can result in transmission damage. Do not overfill the transmis- sion. Overfilling will force fluid out of the case through the main shaft openings. Do not mix types and brands of fluid, because of possible incompatibility. Do not use fluid addi- tives, friction modifiers, extreme-pressure gear fluids, or multiviscosity lubricants.
With the transmission at operating temperature, and the vehicle on a level surface, check the fluid level in the transmission. 1. Clean the area around the fill plug, and remove it from the side of the case. 2. Using your finger or a bent pipe cleaner, see if the fluid is level with the fill opening. See Fig. 1 . 3. If the fluid level is low, check the transmission for leaks, and correct as needed. 4. If needed, add the recommended fluid, until it is level with the lower edge of the fill opening. See Table 1 for approved transmission lubricants. For more information and a complete listing of Eaton approved lubricants, refer to the Eaton website, www.roadranger.com .
For more infor- mation and a complete listing of Meritor ap- proved lubricants, refer to the ZF Meritor web- site, www.zf.com . 5. Clean the fill plug, then install it in the transmis- sion. Tighten the plug as follows: 25 to 35 lbf·ft (34 to 48 N·m) for Eaton Fuller transmissions with 3/4-inch pipe threads. 60 to 75 lbf·ft (81 to 102 N·m) for Eaton Fuller transmissions with 1-1/4-inch pipe threads. 44 lbf·ft (60 N·m) for all ZF Meritor FreedomLine automated transmissions. Century Class Trucks Maintenance Manual, August 2017 26/7