Frame and Frame Components 31 Holland FWS1 1 1. Disconnect the tractor from the trailer. For in- structions, see the Century Class Driver’s Manual . 2. Thoroughly steam clean the fifth wheel. 3. Check the fifth wheel plate for cracks. Check for sharp edges on top; the chamfer should be 1/8 to 1/4 inch (3 to 6 mm). 4. When the wheel is locked, the safety latch must swing free and fall freely into position. See Fig. 2 . 2 1 03/28/2013 f311140 1. Release Handle 2. Lever Bar Fig. 3, Lever Bar and Release Handle Alignment 2 hardened washers. Do not re-use bolts, nuts, and washers on fifth wheel mountings. 3 9.
After inspecting the fifth wheel, lubricate all mov- ing parts with a chassis or multipurpose grease. See MOP 31–02 for lubrication instructions. Holland FW35 4 1. Thoroughly steam clean all fifth wheel compo- nents before inspection. f311052 10/29/2007 1. Lubricant Grooves 2. Safety Latch 3. Release Handle 4. Mount 2. Check for cracks in the fifth wheel assembly, mounting brackets, and mounting parts. 3. Check the fastener torques on the fifth wheel assembly and fifth wheel mounting. Tighten bolts and nuts as needed. Replace missing or dam- aged bolts. Fig. 2, Holland FWS1 Fifth Wheel 5. The lever bar and release handle must be in proper alignment. See Fig. 3 .
Compare the lever bar and release handle alignment to a new, or a properly operating lever bar and release handle. Replace any bent or misaligned lever bar or re- lease handle. 4. Inspect the fifth wheel for bent, worn, damaged, and missing parts; replace them as needed with genuine Holland parts. 5. Using a Holland Kingpin Lock Tester (Holland tool number TF-TLN-5001, available through the PDCs as HLD TFTLN5001), check the operation of the locking mechanism by opening and closing the locks. See Fig. 4 . 6. Check all cotter pins for cracking or damage. Re- place any cotter pin that shows any signs of damage. 7.
Check all mounting bolts for signs of fatigue, and tighten them to the proper torque. For torque specifications, see Group 00 . Inspect all angles, plates, and brackets for cracks or other damage. 6. After inspecting the fifth wheel, lubricate all mov- ing parts with a chassis or multipurpose grease. See MOP 31–02 for lubrication instructions. 8. Replace cracked, worn, or damaged parts with new parts. Replace all loose mounting bolts with 5/8–11 SAE grade 8 bolts, grade C locknuts, and Castloc II and Simplex Series 1. Disconnect the tractor from the trailer. For in- structions, see the vehicle driver’s manual. Century Class Trucks Maintenance Manual, January 2016 31/3