Frame and Frame Components 31 5. The lever bar and operating handle must be in proper alignment. See Fig. 6 . Compare the lever bar and operating handle alignment to a new, or a properly operating lever bar and operating handle. Replace any bent or misaligned lever bar or operating rod. A 1 04/11/2011 f310887 B A. The nut and washer should be snug against the fifth wheel. B. The locks should be completely closed around the kingpin. 2 Fig. 4, Holland Fifth Wheel Properly Closed 2. Thoroughly steam clean the fifth wheel. 04/11/2011 f310470 3. Check the fifth wheel plate for cracks. Check for sharp edges on top; the chamfer should be 1/8 to 1/4 inch (3 to 6 mm). 1. Operating Handle 2.
Lever Bar Fig. 6, Lever Bar and Operating Handle Alignment 4. When the wheel is locked, the safety latch must swing free and fall freely into position. See Fig. 5 . 6. Check all cotter pins for cracking or damage. Re- place any cotter pin that shows any signs of damage. 7. Level the fifth wheel plate to a horizontal posi- tion. Measure the height from a stationary mounting point (see Fig. 7 , Ref. 3), such as the frame rail to the top of the fifth wheel plate (Ref. 1). Pry up on the fifth wheel plate (Ref. 4) below the pin boss, and measure the vertical move- ment (Ref. 5).
The bracket connection provides a 9/32-inch (7-mm) vertical clearance to provide cushioning and to avoid downward pin-loading while retaining minimum plate lift. If the plate lift (Ref. A) exceeds 5/16 inch (8 mm) as a result of wear or rubber deterioration, install new, stan- dard or oversized bracket-shoe rubber pads; see Group 31 of the Century Class Trucks Workshop Manual for replacement instructions. NOTE: Do not measure plate lift immediately after a trailer has been uncoupled from the fifth wheel. The rubber may have taken a temporary 1 2 3 4 10/26/2010 f310353b 1. Lubricant Grooves 2. Safety Latch 3. Lock Control Handle 4. Mount Fig.
5, Simplex Series Fifth Wheel Century Class Trucks Maintenance Manual, January 2016 31/4