Freightliner — Century Class Maintenance Manual

Frame and Frame Components 31 31–03 Frame Fastener Torque Check 1 Frame brackets and components secured with Huck- bolt® fasteners do not require a torque check, how- ever, they should be inspected for damage. Frame brackets and components secured with conventional bolts and nuts are to be checked at initial mainte- nance (IM). See Fig. 13 for pre-EPA07 engine mounts. Check the torque of frame fasteners to off- set the effects of "bedding in" (or seating). When possible, always check the torque of the nut, not the bolt head. This will give a true torque reading by eliminating bolt body friction. When checking the torque of frame fasteners, inspect the frame for cracks and other damage.

Set a click-type torque wrench to the maximum torque of the fastener you are checking. Apply pressure until the torque wrench clicks. Do not loosen the bolt to check the torque. See the applicable torque table in Group 00 for torque specifications. 2 4 5 3 6 7 5 8 9 10 NOTICE Make sure frame fasteners are properly tightened. Continued vehicle operation with loose fasteners could result in bracket or frame damage. 11 13 2 10 NOTE: Engine supports on vehicles built from January 2007 do not require checking. 12 Inspect and check the fasteners at the following locations: 03/30/95 f220054 1. Capscrew, 3/4– x 4.5 Inch, Grade 8 2. Washer, 3/4 Inch 3. Engine Leg 4.

Capscrew, 1/2–13 x 1.5 Inch, Grade 8 5. Washer, 1/2 Inch 6. Upper Isolator 7. Rear Engine Mount 8. Nut, 5/16–18 9. Capscrew, 5/8–11 x 2.5 Inch, Grade 8 10. Washer, 5/8 Inch 11. Lower Isolator 12. Nut, 3/4–10 13. Nut, 5/8–11 Axle Stops Engine Trunnion Supports Equalizer Brackets Exhaust Brackets Fifth Wheel Legs Fifth Wheel Mountings Frame Crossmembers and Gussets Front Frame Brackets Front Suspension Spring Brackets Fig. 13, Rear Engine Mount Assembly (pre-EPA07 engines) Fuel Tank Brackets Shock Absorbers Radius Rods Rear Engine Supports All Other Frame Fasteners Rear Suspension Spring Brackets Any component that shows signs of cracking, or other damage, must be repaired or replaced.

See the Century Class Trucks Maintenance Manual, January 2016 31/9