Suspension 32 1 1 4 A 2 3 f320112a 05/27/93 A. Minimum gap of 3/8" (9.5 mm). 1. Forward (no. 1) Spring Hanger 2. Spring Eye Pin 3. Rear (no. 2) Spring Hanger 4. Rear (no. 3) Extension Fig. 12, RTE Suspension (unloaded) 09/15/95 f320421 1. Rust Inspection Area Fig. 11, Hendrickson RS Series Rust Inspection and loss of vehicle control. This could result in serious personal injury or property damage. 4 4. Inspect the cam surface of the number-two spring hanger for wear due to operating mileage. Also, inspect the outside legs for wear, which can be caused by worn spring eye bushings. NOTE:
RTE2 (extended-leaf-spring) suspen- sions require a minimum gap of 3/8 inch (9.5 mm) between the cam surface of the number- two spring hanger and the top of the main leaf in the unloaded condition. See Fig. 12 . If this gap is less than 3/8 inch (9.5 mm), the extended-leaf portion of the spring will not per- form satisfactorily for an empty ride. 1 2 f320422 08/16/96 1. Frame Bracket 2. Leaf Spring 3. Wood Block 4. Pry Bar 3 5. Inspect the cam surface on the number-three spring hanger (extended-leaf-springs only) for wear. Excessive wear will reduce the gap avail- able at the number-two spring hanger. See the previous note. Fig.
13, Hendrickson RT2 and RTE2 Series Frame Bracket Inspection hanger. Attempt to lift the frame hanger, as shown in Fig. 13 . Also, with an empty chassis and the brakes applied, attempt to rock the chas- sis back and forth while observing the spring eye. In either case, if 1/8 inch or more of move- ment is observed, the bushing and pin should be replaced. This also could indicate that a broken 6. Place a block of wood on the leaf spring. See Fig. 13 . Place a pry bar on the block of wood and insert the end of the pry bar under the frame Century Class Trucks Maintenance Manual, January 2016 32/7