Suspension 32 components, loss of vehicle control, and possible personal injury or property damage. 2. Inspect each frame hanger for any evidence of cracks in the vertical mounting flange. See Fig. 9 . 2 1 1 09/15/95 f320420 1. Crack In Inspection Area Fig. 10, Hendrickson RS Series Horizontal Mounting Flange 09/15/95 f320419 1. Frame Rail 2. Crack In Inspection Area torqued to specification to prevent wear of the beam center bushings into the legs of the saddles. See Group 00 of this manual for torque specifications. Hendrickson RT2 and RTE2 Series Fig. 9, Hendrickson RS Series Vertical Mounting Flange 3.
Inspect each frame hanger for evidence of cracks in the horizontal mounting flange adjacent to the vertical drive pin area. See Fig. 10 . 1. Park the vehicle on a level surface, apply the parking brakes, and chock the front tires. 4. Inspect each frame hanger for severe rust on the horizontal mounting flange adjacent to the verti- cal drive pin area. See Fig. 11 . Raise the rear of the vehicle until the rear wheels are suspended in the air, then support the ve- hicle with safety stands. 5. Inspect the load cushions for cuts and swelling.
Cushions cut by the retaining lips of the saddles or frame hangers indicate the cushions may not be the correct hardness or configuration for the vehicle operation. 2. Check the torque of the number-one spring hanger (double-lock-bolt design) lock bolt nuts. If a loose connection has caused pin hole wear, replace the hanger. 6. Inspect the lower side of the vertical drive bush- ings for evidence of torn or shredded rubber. Check that the concave washers are installed with the lips pointing downward. 3. Inspect the pin hole in the outboard leg of the number-one spring hanger (draw-key design) for wear or elongation. 7. Inspect the saddles and saddle cap fasteners for wear.
The allowable thrust washer wear in alumi- num saddles is up to 3/16 inch (4.8 mm) into the saddles as measured at the top of the thrust washer diameter. Check that the locknuts are WARNING Wear at this point requires hanger replacement, or premature fracture of the spring hanger pin may occur, with possible separation of components Century Class Trucks Maintenance Manual, January 2016 32/6