Suspension 32 1 1 A A B 09/27/95 f320432 A. Non-Wear Area B. Wear Area 1. Walking Beam 08/16/96 f320453 A. Measure height here. 1. Left Forwardmost Axle Stop Fig. 8, Walking Beam End Wear Thickness Fig. 7, AirLiner Axle Stop Measurement 6. Rotate the restrictor cans 360 degrees and visu- ally inspect the cans for cracks, severe corro- sion, and distortion. If any of these conditions are present, or the restrictor can is missing, replace the restrictor can. nents. The vehicle is lifted high enough when the beam ends are off of the saddles. Inspect the walking beam for cracks or other damage. If damage is found, replace the walking beam. WARNING Replace all cracked or missing restrictor cans.
Failure to do so could lead to loss of vehicle con- trol, which could result in property damage, seri- ous personal injury, or death. Hendrickson RS Series Keep the vehicle supported by the jack stands for the next operation. 5. Manipulate the walking beam so that a microm- eter, vernier, or dial caliper can be used to deter- mine the wear area thickness on the bottom face. See Fig. 8 . Measurements should be taken a minimum of 1/2 inch from the beam flange edges to eliminate any edge wear that may have occurred. Subtract the wear area thickness (see Fig. 8 , Ref. B) from the thickness at the non- wear area (see Fig. 8 , Ref. A) to determine the amount of wear. 1.
Inspect the frame hanger to frame attaching fas- teners for the proper torque. See Group 00 of this manual for torque specifications. WARNING Be sure that fasteners are torqued correctly. Fas- teners that do not provide a tightly clamped joint between the frame and the hanger can cause pre- mature fracture of the frame hanger, separation of If the beams show any wear greater than 0.062 inch (1.5 mm), a Chalmers wear plate must be installed, or the walking beam must be replaced. Century Class Trucks Maintenance Manual, January 2016 32/5