Freightliner — Century Class Maintenance Manual

Suspension 32 Do not overtighten the bolts in the Barksdale height-control valve housing. The bolts should not be loose, and should not require tightening. Only if necessary, tighten the valve housing bolts 45 lbf·in (500 N·cm). Any damage to the valve housing will void the warranty. A 4 1 Do not attempt to disassemble the Barksdale valve body or the control lever. There are no serviceable parts in the valve, and any disas- sembly will void the warranty. 3 2 NOTICE 5 05/15/95 f320410 A. Measure the length of the overtravel lever between these two points. 1. V-Shaped Mark 2. Adjustment Locknut 3.

Overtravel Lever When removing or loosening a Barksdale height- control valve from a mounting bracket, always hold the valve-side mounting studs in place with an Allen wrench while loosening or tightening the nuts that attach the valve to the bracket. Because the mounting studs are threaded into the valve body, loosening the nuts without holding the studs can tighten the studs, which can crush the valve body and damage the valve. Conversely, tightening the nuts without holding the studs can back the studs out, causing a separation of the two halves of the valve body, and possibly a leak. 4. Cotter Pin 5. Linkage Rod Fig.

6, AirLiner Overtravel Lever and Linkage Rod Measurement tance from the bottom of the forwardmost left axle stop to the top of the axle U-bolt pad. See Fig. 7 , Ref. A. The correct distance for single and dual-drive rear axles is between 2-3/8 inches and 2-7/8 inches (60 to 73 mm). 1. Park the vehicle on a level surface, using a light application of the brakes. Do not apply the park- ing brakes. Shift the transmission into neutral, and build the secondary air pressure to at least 100 psi (690 kPa). Shut down the engine. 5. If the axle stop measurement is not correct, see Group 32 of the Century Class Trucks Workshop Manual for adjustment procedures. 2.

Mark the location of the front and rear tires on the floor, and chock the tires on one axle only. 6. Apply the parking brakes, and remove the chocks. Chalmers Suspension 3. Check the length of the overtravel lever between its pivot points. See Fig. 6 , Ref. A. 1. Chock the front tires then place the transmission in neutral, and release the parking brakes. 3.1 If the vehicle is equipped with an adjust- able leveling valve, the length should be 8 inches (203 mm). If the length is incor- rect, see Group 32 of the Century Class Trucks Workshop Manual for adjustment procedures. 2. Power wash the suspension, or clean it with a hard-bristle brush before performing a visual in- spection. 3.

Inspect the rubber bushings for cracks or other damage. 3.2 If the vehicle is equipped with a fixed lev- eling valve, see Group 32 of the Century Class Trucks Workshop Manual for the overtravel lever length for the rear axle installed in your vehicle. Try to move the torque rod ends using your hands only, and check for any free-play. If free- play is felt, replace the torque rod end bushing. Do not use a pry bar to check for free-play. Use of a pry bar may lead to premature bushing re- placement. 4. On single-drive rear axle configurations, measure the distance from the bottom of the left axle stop to the top of the U-bolt pad.

On tandem (dual- drive) rear axle configurations, measure the dis- 4. Lift the rear of the vehicle and support the frame on jack stands to unload the suspension compo- Century Class Trucks Maintenance Manual, January 2016 32/4