GENERAL FUEL COOLANT AND LUBRICANTS 12 NOTE 1 - After draining and replacing coolant, always precharge the cooling system to maintain the SCA concentration between 1.0 and 2.0 units per 3.8 L. NOTICE: When performing service which requires draining the cooling system, discard the coolant. Reusing coolant can introduce contaminates or over concentrated chemicals, resulting in premature failure of cooling system components. NOTE 2 - To precharge cooling systems larger than 114 L do the following: Install appropriate service filter listed in the above table based on cooling system capacity. Example:
360 L cooling system capacity -15 Units (1) WF-2075 Filter 80 Units The answer represents the additional units required to precharge the cooling system. Four bottles of powder, part number DCA95, will provide a sufficient amount of SCA units (80) to precharge the example cooling system. Install the appropriate service filter at the next and subsequent maintenance intervals. NOTE 3 - Change the coolant filter at every engine oil and filter change interval to protect the cooling system. Maintain a nominal SCA concentration of 1.0 unit per 3.8 L of coolant in the system. Less than 0.5 units per 3.8 L indicates an under-concentrated coolant solution.
More than 2.0 units per 3.8 L indicates an over-concentrated coolant solution. To check the SCA concentration level, use coolant test kit, CC-2626. Instructions are included with the test kit. PC200-6LL/PC220LL-6 01-17 DCA4 UNIT GUIDE Fleetguard Part No. DCA4 Units DCA4 Coolant Filter WF-2070 WF-2071 WF-2072 WF-2073 WF-2074 WF-2075 WF-2076 WF-2077 2 4 6 8 12 15 23 0 DCA4 Liquid DCA60L DCA80L 4 1760 DCA4 Powder DCA95 20