12. For models equipped with a disc brake, install 14. Install the brake shoes. See Figure 4-167. 15. Slide the output flange onto the output shaft. FIGURE 4-168 4606 FIGURE 4-171 4609 the disc. Install the bolts into the disc and tighten to 69 Nm (50.8 ft lb). See Figure 4-165. See Figure 4-168. NOTE 16. Apply a non hardening sealant to the flange FIGURE 4-169 4607 FIGURE 4-172 4610 The following 7 steps are to be performed only on models that have a drum type brake. disc. Install the disc, then install the bolts to hold the disc in place. See Figure 4-169. Tighten the bolts to 49 Nm (36 ft lb). FIGURE 4-170 4608 FIGURE 4-173 4611 13.
Apply Loctite to both bore covers and install them into the bores. See Figure 4-166. 17. Install the bolt lock plate, to hold the bolts in 4-46 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual