8. Assemble the K4 clutch pack. See Figure 4-188. Insert the first plate with outer teeth into the clutch carrier. Plates 10. Measure the distance from the top of the clutch carrier to the backing plate. See Figure 4-190. In the example shown, this measurement was 5.40 mm (.2125"). This is measurement A. 11. Pry upward on the backing plate until the plate is touching the snap ring. See Figure 4-191. Once again, measure the dis- tance from the top of the clutch carrier to the backing plate. In the example shown, this FIGURE 4-192 4630 with outer teeth have a 2.0 mm (.0787") thick- ness. Insert a plate with inner teeth on top of the first plate.
Plates with inner teeth have a FIGURE 4-194 4632 measurement was 3.00 mm (.118"). This is measurement B. FIGURE 4-193 4631 2.5 mm (.0984") thickness. Continue to alter- nate plates until 8 plates with external teeth and 7 plates with internal teeth have been installed. 9. Install the backing plate and then install the snap ring to hold the backing plate in place. See Figure 4-189. FIGURE 4-195 4633 Subtract measurement B from measurement A. 5.40 mm (.2125") measurement A -3.00 mm (.118") measurement B 2.40 mm (.0944") The difference between the two measure- ments must be 2.0 – 2.9 mm (.0787 – .114").
The correct difference between the two mea- surements can be achieved by installing an additional plate with internal teeth that has the correct thickness. Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-51