5. Set the guide ring and then the snap ring on the spring guide. Use a press to force the spring down until the snap ring can be set into its groove. See Figure 4-185. measurement has been completed, remove the plates from the clutch carrier. 7. Insert the thrust washer into the inner plate carrier. Use a depth micrometer to measure NOTE The following steps describe taking measurements and using the measurements to make a calculation. The measurements shown in these steps are an example only. Be sure to take your own measure- FIGURE 4-190 4628 the distance from the top of the carrier to the surface of the thrust washer. See Figure 4-187.
In this example, the distance measured was 47.00 mm (1.850"). This is measurement B. FIGURE 4-188 4626 ments on the transmission you are working on, and perform your own calculation. Subtract measurement B from measurement A. 47.00 mm (1.850") measurement A FIGURE 4-189 4627 FIGURE 4-191 4629 -44.30 mm (1.744") measurement B 2.70 mm (.106") 6. The side of the clutch carrier that will have the plates installed first, has a smaller needle bearing than the other side of the clutch car- rier. Insert into the clutch carrier, the first plate with external teeth. The thickness of this plate should equal 2.0 mm (.0787"). On top of this plate, place a plate with internal teeth.
Place the backing plate on top of this plate. Use a depth micrometer to measure from the top of the clutch carrier hub to the surface of the backing plate. See Figure 4-186. In this exam- ple, the distance measured was 44.30 mm (1.744"). This is measurement A. After the This calculation will derive the distance that the inner plate carrier will overlap the first inner plate. This distance must be a minimum of 2.50 mm (.0984"). If the distance is less than 2.50 mm, a second inner toothed plate should be installed on the piston side. Additional plates with external teeth can be installed beneath the backing plate. 4-50 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual