daewoo — Daewoo Wheel Loader Shop Manual

bolts to 25 Nm (18 ft lb). 26. If the machine is not equipped with a speed- ometer, install Loctite on a bore plug and tap it into the transmission. See Figure 4-179. K3/K4 Clutch Pack Assembly FIGURE 4-185 4623 FIGURE 4-187 4625 1. Install a needle bearing into each side of the clutch carrier. See Figures 4-180 and 4-116. Exercise caution to prevent damage to the needles. Also exercise caution to prevent damage to the bleeder valves in the clutch carrier. See Figure 4-181. 2. Install seal rings into the inner and outer grooves on both pistons. See Figure 4-182. 3. Use an installation sleeve to install the piston on the shaft. This will help prevent damage to the inner seal.

Install a piston on both sides of the clutch carrier. See Figure 4-183. 4. Install a lower spring guide, compression spring, and upper spring guide into the clutch carrier. See Figure 4-184. FIGURE 4-186 4624 Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-49