daewoo — Daewoo Wheel Loader Shop Manual

the required amount of end play for this example, use a shim that is 2.90 mm (.114") thick. 5. Install a dummy shaft into the transmission until it aligns the objects in the clutch pack. See Figure 4-201. Rotate the transmission 90° so that the clutch pack is now horizontal instead of vertical. FIGURE 4-215 4653 3.00 mm (.118") -2.90 mm (.114") FIGURE 4-218 4656 6. Pull the dummy shaft back so that the washers and shims can be installed. See Figure 4-202. 7. Set the plastic washer, grooved disc, and the FIGURE 4-216 4654 .10 mm (.0039") FIGURE 4-219 4657 shim calculated in Step 45 onto the part of the dummy shaft that extends inside the transmis- sion.

The plastic washer must be against the housing. See Figure 4-203. Slide the clutch pack back onto the bearing driver. Rotate the transmission 180° to gain access to the other end of the clutch pack. 8. Install the 3 rectangular seal rings on the K3/K4 shaft. See Figure 4-204. Be sure that the roll pin is installed in the shaft. FIGURE 4-217 4655 4. Slide the clutch pack into the transmission housing. See Figure 4-200. 4-56 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual