daewoo — Daewoo Wheel Loader Shop Manual

9. Before installing the shaft in the transmission, apply Loctite to the bolts. Heat the bore in the transmission housing before installing the shaft. See Figure 4-205. 11. Use compressed air to test both clutches to make sure that they are working. See Figure 4-207. 12. Use a dial indicator to check the end play of 10. Place the gasket in position on the shaft. Slide the shaft into the bore and the clutch pack. See Figure 4-206. Install the bolts to hold the shaft in place. Tighten the bolts to 25 Nm (19 ft lb). See Figure 4-206. FIGURE 4-221 4659 the shaft. See Figure 4-208. Allowable end play is .10 – .30 mm (.0039 – .0118"). Use shims to correct the end play, when necessary.

FIGURE 4-220 4658 FIGURE 4-222 4660 Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-57