daewoo — Daewoo Wheel Loader Shop Manual

Reverse Gear Type A – Assembly 1. Grease the rollers and install them into the gear. See Figures 4-209 and 4-89. 4. Position the gear inside the transmission. See Figure 4-212. Slide the gear shaft through the bore and through the gear. FIGURE 4-225 4663 FIGURE 4-223 4661 2. Install the roll pin to hold the shaft to the flange. See Figure 4-210. Apply Loctite to the threads of the set screw and thread the set screw into the roll pin bore. 5. Install the screws through the shaft flange and tighten them. See Figure 4-213. 6. Place a thrust washer on the gear shaft. See Figure 4-214. Install the snap ring to hold the washer in place. FIGURE 4-224 4662 FIGURE 4-226 4664 3.

Install the gasket on the flange. See Figure 4-211. Insert the spring into the shaft. 4-58 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual