Reverse Gear Type B – Assembly 1. Insert the angle ring inside the gear. See Figure 4-215. 4. Install the gasket on the flange. Position the gear inside the transmission. See Figure 4-218. Slide the shaft through the FIGURE 4-229 4667 FIGURE 4-227 4665 2. Use grease to install the rollers inside the gear. See Figure 4-216. bore and through the gear. Install the bolts into the flange and tighten them. 5. Install the roll pin into the thrust washer. See Figure 4-219. Use the bolt and washer to hold the thrust washer to the shaft. Tighten the bolt to 49 Nm (36 ft lb). Push the roll pin into the shaft. 3. Install the roll pin into the bore in the flange. See Figure 4-217.
FIGURE 4-228 4666 FIGURE 4-230 4668 Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-59