daewoo — Daewoo Wheel Loader Shop Manual

KR/K2 Clutch Pack Assembly 1. To assemble the clutch pistons, perform Steps 1 – 7 under the heading K3/K4 Clutch Pack ments on the transmission you are working on, and perform your own calculation. FIGURE 4-231 4669 Assembly. FIGURE 4-233 4671 2. Install the clutch plates on the side of the clutch carrier that has the larger bearing. See Figures 4-220 and 4-105. The first plate to be inserted must have teeth on the outer FIGURE 4-232 4670 circumference. Outer toothed plates have a thickness of 2.0 mm (.0787"). The second plate to be inserted must have teeth on the inner circumference. This plate has a thick- ness of 2.5 mm (.0984").

Continue to alternate plates until all plates are installed. Install the backing plate on top of the clutch plates. Install the snap ring into the groove above the backing plate. FIGURE 4-234 4672 NOTE The following steps describe taking measurements and using the measurements to make a calculation. The measurements shown in these steps are an example only. Be sure to take your own measure- 4-60 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual