daewoo — Daewoo Wheel Loader Shop Manual

3. Measure the distance from the top of the clutch carrier to the backing plate. See Figure 4-221. In the example shown, this measurement was 5.40 mm (.2125"). This is measurement A. 4. Pry upward on the backing plate until the plate is touching the snap ring. See Figure 4-222. Once again, measure the distance from the top of the clutch carrier to the backing plate. In the example shown, this measurement was 3.20 mm (.1259"). This is measurement B. Subtract measurement B from measurement A. 5.40 mm (.2125") measurement A -3.20 mm (.1259") measurement B 2.20 mm (.0866") FIGURE 4-237 4675 The difference between the two measure- ments must be 2.2 – 2.9 mm (.0866 – .114").

The correct difference between the two mea- FIGURE 4-235 4673 surements can be achieved by installing an additional plate with internal teeth that has the correct thickness. FIGURE 4-238 4676 FIGURE 4-236 4674 Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-61