daewoo — Daewoo Wheel Loader Shop Manual

2. Measure the distance from the top of the clutch carrier to the backing plate. See Figure 4-221. This is measurement A. 3. Pry upward on the backing plate until the plate is touching the snap ring. See Figure 4-222. Once again, measure the dis- tance from the top of the clutch carrier to the backing plate. This is measurement B. 4. Subtract measurement B from measurement A. This difference must equal 2.0 – 2.9 mm (.0787 – .114"). The correct difference between the two measurements can be achieved by installing into the clutch carrier, an additional plate with internal teeth that has the correct thickness. FIGURE 4-240 4678 KV Spur Gear Assembly – Type C 7. Apply grease to the parts.

See Figure 4-241. Install the parts into the spur gear. KV Spur Gear Assembly – Type A 5. Apply grease to the bearings and the washer. See Figure 4-239. Install these parts into the FIGURE 4-241 4679 FIGURE 4-239 4677 8. Insert the thrust washer into the clutch carrier. See Figure 4-242. Insert the spur gear into the clutch carrier. spur gear. KV Spur Gear Assembly – Type B 6. Apply grease to the bearing rollers and the washers. See Figure 4-240. Install these parts into the spur gear. The longest rollers must be assembled closest to the outside of the spur gear hub. FIGURE 4-242 4680 4-62 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual