daewoo — Daewoo Wheel Loader Shop Manual

Shim Selection 1. Place the split tab washer and the grooved disc over the bore in the bottom of the trans- mission. See Figure 4-243. Lay the gasket in place over the bore on the top of the transmis- sion. Use a depth micrometer to measure from the gasket on the top of the bore, to the surface of the grooved disc in the bottom of the bore. In this example, this distance is FIGURE 4-245 4683 The allowable amount of end play is between 0.10 and 0.30 mm (.0039 and .0118"). To calculate the end play, perform the following calculations.

252.00 mm (9.9210") measurement A -27.00 mm (1.0629") measurement B 225.00 mm (8.8581") -224.60 mm (8.8425") measurement C .40 mm ( .0156") end play FIGURE 4-243 4681 To bring the shaft within the allowable amount of end play, choose a .20 mm (.0078") shim. 2. Measure the distance from the first shoulder on the shaft to the shaft flange. See 252.0 mm (9.921"). This is measurement A. .40 mm (.0156") end play -.20 mm (.0078") shim .20 mm (.0078") end play 4. Install the clutch pack into the transmission. See Figure 4-246. Do not install the shaft at this time. FIGURE 4-244 4682 Figure 4-244. In this example, this distance is 27.0 mm (1.0629"). This is measurement B. FIGURE 4-246 4684 3.

Set the clutch carrier on a flat metal plate. See Figure 4-245. Measure the distance from the bottom of the clutch carrier to the top edge of the clutch carrier bore. In this exam- ple, this distance is 224.7 mm (8.846"). This is measurement C. Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-63