daewoo — Daewoo Wheel Loader Shop Manual

2. Measure the distance from the bottom of the gauge pin to the snap ring. See Figure 4-266. For this example, this distance measured 32.8 mm. This is measurement A. FIGURE 4-270 4708 4. Install the gasket and shim on the transmitter. See Figure 4-268. Apply seal ring compound FIGURE 4-268 4706 3. Measure the distance from the bottom of the transmitter to the seal ring on the transmitter. See Figure 4-267. For this example, this distance measured 33.8 mm. This is FIGURE 4-271 4709 to the transmitter threads. Install the transmit- ter and tighten it to 50 Nm (36.9 ft lb). FIGURE 4-269 4707 measurement B. Calculate the shim thickness as follows.

32.8 mm (1.291") measurement A .8 mm (.031") desired gap 32.0 mm (1.259") 33.8 mm (1.33") measurement B 32.0 mm (1.259") 1.8 mm ( .070") necessary shim thickness FIGURE 4-272 4710 5. If the transmission was not equipped with a transmitter, install a new seal ring on the threaded bore plug. Tighten the plug into the transmitter bore. See Figure 4-269. 6. Use socket head screws to tighten the bracket. See Figure 4-270. Apply Loctite to 4-68 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual