3. Insert the steering pump into the bore in the transmission. See Figure 4-262. Rotating the transmission output shaft will help the pump working on, and perform your own calculation to derive the correct shim thickness for your transmit- ter. FIGURE 4-264 4702 FIGURE 4-266 4704 gear mesh with the gear inside the transmis- sion. Install bolts from inside the transmission. Install and tighten nuts on the studs and the bolts. 1. The gap between the transmitter and the gear inside the transmission must be between .70 – 1.0 mm (.0275 – .0393"). Insert a gauge pin into the transmitter bore. See Figure 4-265. Mark with the snap ring, the dis- 4.
For transmissions that are not equipped with an emergency steering pump, apply Loctite to the bore plug and use a bearing driver to install the plug into the bore. See Figure 4-263. 5. Coat set screws with Loctite and install them into the threaded holes around the bore plug. See Figure 4-264. RPM Transmitter NOTE FIGURE 4-267 4705 tance to the surface of the transmission case. FIGURE 4-265 4703 The following steps describe taking measurements and using the measurements to calculate a shim thickness. The measurements shown in these steps are an example only. Be sure to take your own measurements on the transmission you are Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-67