bores from the side of the transmission that the shim washers were installed from. 8. Install the 3 seal rings on the KR/K2 shaft. See Figure 4-255. FIGURE 4-261 4699 Emergency Steering Pump 1. Apply Loctite to the bolts and studs for the steering pump. Install the studs and tighten them. See Figure 4-260. FIGURE 4-259 4697 9. Remove the dummy shaft from the KR/K2 bore. Heat the bore. See Figure 4-256. 2. Apply grease to the O-ring for the steering pump. Install the O-ring into the groove in the 10. Place the gasket over the KR/K2 bore. Insert the KR/K2 shaft into its bore. See Figure 4-257. Be sure to align the mark on the shaft flange with the mark on the bore shoulder.
FIGURE 4-262 4700 pump. See Figure 4-261. FIGURE 4-260 4698 11. Install the bolts and nuts into the KR/K2 shaft flange and tighten to 25 Nm (18.4 ft lb). Use compressed air to check the operation of both clutch pistons. See Figure 4-258. 12. Install a dial indicator and check the end play on the KR/K2 shaft. See Figure 4-259. End play should be within the range of .10 – .30 mm (.0039 – .0118"). To keep end play within the range, use a shim. 13. Repeat Steps 8 through 12 to install the shaft into the other clutch bore. FIGURE 4-263 4701 4-66 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual