ate the required endplay, perform the follow- ing calculations. 7.15 mm (.281") measurement A -6.50 mm (.2559") measurement B .65 mm (.02559") total endplay FIGURE 4-293 4731 13. Place the gasket on the flange surface. Measure the distance from the top outer edge of the bearing to the flange surface. See FIGURE 4-296 4734 To bring the endplay within the required range, select a .30 mm (.0118") shim. .65 mm (.02559") total end play -.30 mm (.0118") shim FIGURE 4-294 4732 Figure 4-286. In this example, this distance measured 6.50 mm (.2559"). This is measurement B. FIGURE 4-297 4735 .35 mm (.0137") endplay within required .30 – .50 mm range. 14.
Apply grease to the .30 mm shim and install the shim in the pump housing. See Figure 4-287. 15. Install the parts for the converter relief valve into the oil supply flange. See Figure 4-288. FIGURE 4-295 4733 Thread 2 assembly studs into the supply flange. Apply grease to the seal rings on the pump shaft. The required endplay is .30 – .50 mm (.0118 – .0196"). 16. Install the pump on the oil supply flange. See Figure 4-289. To calculate the shim thickness needed to cre- Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-73